P1074464_wt.7z -

To draft a feature using the file (which likely contains a CAD model for a casting or molded part), you should apply a Draft feature to the relevant faces. This feature creates a taper that allows the part to be extracted from its mold easily.

: If a face is too complex, use a "Split Line" to break it into smaller segments before applying the draft to each part individually. p1074464_wt.7z

If the standard feature fails (which often happens on complex surfaces like fenders or casting pockets), consider these professional workarounds: To draft a feature using the file (which

: This is the standard method where you select a "neutral plane" that determines the pull direction. The draft angle is then applied to the faces you select, pivoting them from that plane. If the standard feature fails (which often happens

: Often used for more complex geometry, this method allows you to use a specific edge or curve as the split point for the draft. This is highly recommended for parts with non-planar divisions.

Based on community discussions regarding similar drafted features, here is how you can effectively apply a draft: