: Never connect the PP 2 to an input marked "PHONO" on your receiver, as this will cause severe distortion.
Move the PP 2 away from other equipment (like power transformers) to reduce interference.
Follow these steps to correctly integrate the PP 2 into your audio system: Nad Phono Preamp Pp2 Manual
Plug your turntable's RCA leads into the or MM inputs on the back of the PP 2, depending on your cartridge type. Match the colors: Red for Right (R) and White for Left (L).
: Verify that the PP 2 is connected to a standard Line-Level input and not a Phono input on your receiver. Phono Preamplifier PP 2 - HiFi Gear : Never connect the PP 2 to an
The is a compact, low-noise device designed to add a turntable to modern amplifiers or receivers that only have "Line-Level" inputs (like CD, AUX, or Tuner). It supports both Moving Magnet (MM) and Moving Coil (MC) cartridges via separate inputs and a rear selector switch. 1. Setup & Installation
: Connect the external 24V power supply to the PP 2 and plug it into a wall outlet. A green LED on the front panel indicates the unit is powered. 2. Technical Specifications Match the colors: Red for Right (R) and White for Left (L)
: Use RCA cables to connect the PP 2 Output to a Line-Level input (e.g., CD, AUX, Tuner) on your receiver.