: Move the throttle to zero and the rudder stick to the far left.
: Turn on your transmitter and set the throttle to maximum.
: Power up your transmitter (TX) and FC. Navigate to the "Receiver Test" menu on the LCD. Move your TX sticks and verify the values change correctly (e.g., pushing the stick left should show "Rudder Left"). If they move the wrong way, use your TX's "Reverse" setting. kk2.jpg
: Always remove your propellers before connecting a battery for the first time or performing calibrations to avoid accidental injury. 2. Initial Configuration
Based on the file reference "kk2.jpg," this guide covers the , a popular and budget-friendly board used for building DIY quadcopters. This controller is unique because it features a built-in LCD screen and buttons, allowing you to configure your drone without needing a computer. 1. Hardware Assembly : Move the throttle to zero and the
: Plug your receiver outputs into the left side of the board. Follow the pin definitions for Aileron, Elevator, Throttle, and Rudder.
: To prepare the motors for flight, move the throttle to zero and the rudder stick to the far right . A red LED or an "Armed" message on the screen will appear. Navigate to the "Receiver Test" menu on the LCD
This step ensures all motors start at the same time and respond equally to your throttle: : Ensure propellers are OFF .