Once the tub assembly is extracted from the machine's casing—a feat that often requires unhooking the heavy tension springs and dampers—the real precision work begins. The outer tub must be split open by removing the perimeter bolts or clips. This reveals the inner stainless steel drum. With the drum removed, the worn bearings and the rubber oil seal are visible, pressed into the rear of the outer tub.
The final stage is the reassembly of the appliance, essentially following the disassembly steps in reverse order. It is critical to ensure the tub gasket is correctly positioned between the two halves of the outer tub before tightening the bolts, as a misaligned seal will lead to leaks. Once the drum is secured and the internal components like the motor, heating element, and drive belt are reattached, the machine should be checked for stability. How to fit and change Hotpoint Washine Machine Bearings
The process begins with a rigorous commitment to safety; the machine must be disconnected from both the power supply and the water source before any panels are removed. Because most Hotpoint models are designed with a "split tub," the repair requires a systematic teardown of the machine. This involves removing the top panel, the rear access plate, and the drive belt. The technician must then disconnect the heating element, the motor wiring, and the various pressure hoses that anchor the tub to the cabinet. Once the tub assembly is extracted from the
Removing the old, worn bearings usually involves carefully driving them out of the housing using a hammer and a suitable drift or punch. Great care is necessary during this stage to avoid damaging the plastic tub or the bearing seat. After removal, the housing should be thoroughly cleaned of any debris, rust, or lime scale. The new bearings are then seated into the clean housing, ensuring they are perfectly level and flush to prevent imbalance during future operation. A new water seal must also be fitted and properly lubricated with high-quality, waterproof grease to protect the new bearings from moisture. With the drum removed, the worn bearings and